Airflow Uno hab Installation And Operating Instructions Manual - Page 10

Browse online or download pdf Installation And Operating Instructions Manual for Heating System Airflow Uno hab. Airflow Uno hab 16 pages. Cavity wall decentralised mechanical ventilation with heat recovery unit
Also for Airflow Uno hab: Instructions (2 pages), Installation Kit (16 pages), Maintenance Manual (2 pages)

Print Page

CHAPTER 6

SERVICING AND

MAINTENANCE

WARNING

5.1

Opening and closing the inner panel

The inner panel is fully open upon delivery (fig.13).

In order to close the inner panel, turn panel two full turns clockwise until it "Clicks" into position (fig.14)

Inner panel

open

6.0

Servicing and maintenance

WARNING!

Touching live parts will lead to electric shock.

Before any servicing and maintenance work, isolate the unit from the mains power supply and protect

against being switching on again!

WARNING!

The rotating impeller can crush fingers.

Before any servicing and maintenance work, isolate the fan from the mains power supply and protect

against being switching on again!

– Excessive deposits of dirt, dust, grease, etc. on the impeller, motor, protection guard and, above all, between the

housing and the impeller, are not permitted, as these can lead to an unbalance in the impeller, overheating of the

motor or the blocking of the impeller. In such cases, the unit must be cleaned.

– In cases of longer periods of standstill, maintenance must be carried out when the unit is restarted.

– In case of standstill or storage for more than 2 years, the fan must be replaced.

Note the following:

• Remove deposits of dirt, e.g. on protection guards

• Visual inspection, replace damaged parts

• Freewheeling of the impeller, is impeller blocked, see Fault causes 6.3

• Vibrations – see Fault causes 6.3

• Fan unit must be inserted up to the "outer panel" stop in the wall installation sleeve

6.1

Filter change

After the set time interval for the filter change, the upcoming filter change will be indicated on the controller by the

"flashing" of all ventilation stage LEDs. Proceed as follows:

1. Remove inner panel (fig.15).

2. Replace Coarse 50% filter (fig.16)

Accessories: Set/2 pcs Coarse 50% filter, Part No: 90001014

3 . The inner panel is re-attached after the filter change. Ensure that the inner panel is re-inserted with the opening at

the top .

4. Then hold down both buttons on the controller for longer than two seconds and confirm the filter change.

Remove

inner panel

Unohab Unit

fig.13

Close inner panel

by turning

fig.15

Installation and Operating Instructions

Replace

Coarse 50%

filter

fig.14

"Click"

fig.16