IKEA 504.756.18 Manual - Page 26

Browse online or download pdf Manual for Dishwasher IKEA 504.756.18. IKEA 504.756.18 36 pages.

Print Page

ENGLISH

Problem and alarm code

The programme lasts too

long.

The remaining time in the

display increases and skips

nearly to the end of the pro‐

gramme duration.

Small leak from the appli‐

ance door.

The appliance door is difficult

to close.

The appliance door opens

during the wash cycle.

Rattling or knocking sounds

from the inside of the appli‐

ance.

The appliance trips the cir‐

cuit-beaker.

Once you have checked the appliance,

deactivate and activate the appliance. If the

problem occurs again, contact an Authorised

Service Centre.

For alarm codes not described in the table,

contact an Authorised Service Centre.

Possible cause and solution

• If the delay start option is set, cancel the delay setting or

wait for the end of the countdown.

• Activating options can increase the programme duration.

• This is not a defect. The appliance is working correctly.

• The appliance is not levelled. Loosen or tighten the ad‐

justable feet (if applicable).

• The appliance door is not centred on the tub. Adjust the

rear foot (if applicable).

• The appliance is not levelled. Loosen or tighten the ad‐

justable feet (if applicable).

• Parts of the tableware are protruding from the baskets.

• The AutoOpen is activated. This function opens the appli‐

ance door during the drying phase to improve the drying

performance and let the dishes cool down. The door re‐

mains ajar.

– The duration of the drying phase and the door open‐

ing time vary depending on the selected programme

and options.

– When the AutoOpen opens the door, the display

shows the remaining time of the running programme.

If you don't want the door to automatically open, deacti‐

vate AutoOpen. Refer to "Settings".

• The tableware is not properly arranged in the baskets. Re‐

fer to basket loading leaflet.

• Make sure that the spray arms can rotate freely.

• The amperage is insufficient to supply simultaneously all

the appliances in use. Check the socket amperage and the

capacity of the meter or turn off one of the appliances in

use.

• Internal electrical fault of the appliance. Contact an Au‐

thorised Service Centre.

Warning! We do not recommend

using the appliance until the

problem has been completely

fixed. Unplug the appliance and

do not plug it in again until you

are certain that it operates

correctly.