IKEA LAGAN Installation Instructions Manual - Page 12

Browse online or download pdf Installation Instructions Manual for Dishwasher IKEA LAGAN. IKEA LAGAN 18 pages. Examples of the load of the basket
Also for IKEA LAGAN: Assembly Instructions Manual (8 pages), User Manual (20 pages), User Manual (16 pages), User Manual (20 pages), Instructions Manual (48 pages), User Manual (16 pages), User Manual (24 pages), Manual (28 pages), Instruction Manual (24 pages), User Manual (24 pages), Manual (24 pages), Manual (4 pages), User Manual (12 pages), Manual (24 pages), Assembly Instructions Manual (20 pages), Installation Manual (20 pages), Manual (28 pages), Manual (32 pages), Manual (44 pages), Manual (16 pages), Manual (16 pages), Manual (24 pages), Manual (28 pages), Manual (28 pages), User Manual (28 pages), Manual (40 pages), Manual (48 pages), Use & Care Manual (25 pages), Manual (44 pages), Manual (40 pages), Manual (28 pages), Manual (28 pages), User Manual (24 pages), Manual (48 pages), User Manual (16 pages), Manual (48 pages), Quick Start Manual (4 pages), Installation Instructions Manual (16 pages), Manual (28 pages), Manual (28 pages), Manual (44 pages), Manual (48 pages), Manual (16 pages), Manual (32 pages), Manual (24 pages), Manual (25 pages), Manual (18 pages), User Manual (28 pages), Manual (44 pages), Manual (24 pages), Manual (32 pages), Manual (18 pages), Manual (48 pages), Manual (29 pages), Manual (29 pages), Manual (34 pages), Installation Instructions Manual (42 pages)

Print Page
IKEA LAGAN Installation Instructions Manual
Use pressure regulators suitable
for the gas pressure indicated
in the Instruction.
-
The gas nozzles must
changed by After Sales Service
or a qualified technician.
-
Nozzles not supplied with the
appliance must be ordered
from After Sales Service.
-
Adjust the minimum setting of
the taps.
NOTE: when liquid petroleum gas is
used (G30/G31), the minimum gas
setting screw must be tightened as far
as it will go.
IMPORTANT: should you experience
difficulty in turning the burner knobs,
please contact the After Sales Service
for the replacement of the burner tap if
found to be faulty.
Replacing the injectors
(see paragraph "injector table")
-
Remove grids (A).
-
Extract burners (B).
-
Using
a
spanner
appropriate size unscrew the
injector
(C),
injector to be replaced.
-
Replace
it
with
injector suitable for the
new type of gas.
-
Re-assemble the injector in (D).
Before
installing
remember to affix the gas
calibration plate supplied with
the injectors in such a way
that it covers the existing
information relating to gas
calibration.
be
of
the
unscrew
the
the
the
hob,
Adjusting minimum gas setting of
taps
To ensure that the minimum setting is
correctly adjusted, remove the knob (E)
and proceed as follows:
-
tighten screw to reduce the
flame height (-);
-
Loosen screw to increase the
flame height (+).
The adjustment must be performed
with the tap in minimum gas setting
position (small flame).
-
The primary air of the burners
does not need to be adjusted.
12