Makita 6226DWE Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Drill Makita 6226DWE. Makita 6226DWE 19 pages. 9.6 v i2 v 14.4 v
Also for Makita 6226DWE: Instruction Manual (19 pages), Instruction Manual (19 pages), Instruction Manual (19 pages)

Print Page

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge

*Always switch off the tool before inser-

tion or removal of the battery cartridge.

To remove the battery cartridge, with-

draw it from the tool while pressing the

buttons on both sides of the cartridge.

*To

insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slio it into

Battery &ridge

place. Always insert it

all

the way until it locks in place with a little click. If not, it may

accidentally fall out of the tool, causing injury to you or someone around you.

Do not use force when inserting the battery cartridge. If the cartridge does not slide in

easily, it is not being inserted correctly.

Charging

Plug the battery charger into your power

source.

*Insert the battery cartridge

that the

plus and minus terminals on the battery

cartridge are on the same sides as their

respective markings on the battery

charger. Insert the cartridge fully into the

port so, that it rests on the charger port

floor.

charging will begin.

When the battery cartridge is inserted, the charging light color will flash in red color and

When charging is completed, the charging light goes out.

If you leave the battery cartridge in the charger after the charging cycle is complete, the

*After charging, remove the battery cartridge from the charger and unplug the charger

CAUTION:

.The battery charger is for charging Makita battery cartridge. Never use it for other pur-

poses or for other manufacture's batteries.

When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period of time, it may not accept a full charge. This is a normal condition and

does not indicate a problem. You can recharge the battery cartridge fully after discharging

it completely and recharging

couple of times.

When you charge a battery cartridge from a just-operated tool or

battery cartridge

which has been left in a location exposed to direct sunlight or heat for a long time, let

cool off. Then reinsert it and try to charge it once more.

When you charge

new battery cartridge or

battery cartridge which has not been used

for a long period, sometimes the charging light will go out soon. If this occurs, remove

the battery cartridge and reinsert it. If the charging light goes out within one minute even

after repeating this procedure a couple of times, the battery cartridge is dead. Replace it

with a new one.

charger will switch into its "trickle charge (maintenance charge)" mode.

from the power source.