Align-Pilates F2 Assembly Instructions And User's Manual - Page 5

Browse online or download pdf Assembly Instructions And User's Manual for Fitness Equipment Align-Pilates F2. Align-Pilates F2 12 pages. Folding reformer

Print Page

5. Placing the bed in the frame and final assembly

Lower the foot bar to the position closest to the foot board. On the underside of the reformer bed note the

position of the fixed hook - see Fig.9. This hook runs beneath the wheel runner when in use and is there to

prevent the carriage from tipping - care must be taken to hook it under the runner as the bed is installed

into the frame. With assistance, lift up the carriage bed and flip it over, ensuring the springs are pointing

towards the foot bar. Now carefully lower the carriage bed into the

Fig.9

frame, taking care not to hit the frame, gently angle the bed so

that the hook passes beneath the runner of the frame. Once the

carriage bed is in position, gently slide the bed to the foot of the

reformer and attach one of the springs. On the opposite runner to

the hook is a second rotating hook. Rotate this to hold the bed in

place so the carriage cannot fall out when stood up. To remove

the carriage in future the rotating hook must be turned first and

then the bed lifted out at an angle, lifting the rotating hook side of

the reformer first.

Adjustable Hook

Fixed Hook

6. Attaching & adjusting the rope risers

Partially unscrew the rope riser fastener on the end of the frame and insert the rope riser. Pull back on the

fastener and slide the rope riser to the desired height. When happy with the height, let go of the fastener

and twist to tighten, securing it in place. Be sure that the locking pin is engaged in one of the holes of the

rope riser to secure it safely in position Fig.10 & 11.

Fig.11

Fig.10

The F2 allows you to set your ropes at 4 different heights. To adjust the

rope height simply loosen the fastener then pull out to release the pin.

You can then move the rope riser up or down into one of the 4 holes.

Fig.12.

7. Attach the Double Loop handles

Thread the nylon loop of the handle through the rope eyelet and then

thread the loop handle through the nylon eyelet to secure the handle

to the rope as per Figs.13, 14 & 15. Pull tight to check it is secure.

Fig.12

Fig.13

Fig.14

Fig.15