Brother MFC-P2000 Quick Setup Manual - Page 20
Browse online or download pdf Quick Setup Manual for All in One Printer Brother MFC-P2000. Brother MFC-P2000 43 pages. Laser printer / scanner / copier
Print Page
Other Control Features
Sleep Mode
When the machine does not receive data for a certain period of time (time-out), it enters
sleep mode. Sleep mode acts as though the machine was turned off. The default time-
out is 5 minutes. While the machine is in sleep mode, all the lamps are off and it is as
if it was turned off, but the machine can still receive data from the computer. Receiving
a print file or document automatically wakes up the machine to start printing. Pressing
the switch also wakes up the machine.
Note
When the machine goes into sleep mode, the fan will not stop until the print engine
has cooled down.
Sleep mode allows the print engine to cool, so the temperature of your room and how
long the machine has been in sleep mode affects the warm-up time. This warm-up
time can take up to 30 seconds. The Ready lamp blinks to indicate that the machine
is warming up.
You can change the timeout for sleep mode with the supplied machine driver or
Remote Printer Console program . Refer to the Help section in the printer driver or
RPC program for more information about the sleep mode setting.
Test Print Mode
The machine has the following test print mode. Follow these steps:
1. Make sure that the top cover is closed.
2. Hold down the switch and turn on the power switch. Keep the switch depressed
until the Drum lamp comes on.
The Drum lamp lights to indicate that the machine is in the test print mode.
3. Press the switch again to execute the test print or hold down the switch to select
another option and release the switch to execute the selected option.
The test print modes are as follows:
Lamp Lit Choice
Drum
Test sample
page
Alarm
Print Config
& Print Fonts I
Ready
Factory Reset The machine is restored to the factory setting and
Data
Hex Dump
Print
Function
The machine prints a test sample page.
The machine returns to the ready status after printing.
The machine prints the current configuration of the
machine and a list of the internal fonts.
The machine returns to the ready status after printing.
permanent fonts and macros are cleared.
The machine returns to the ready status after printing.
The machine can print data as hexadecimal values, so that
you can check data errors and problems. To exit from this
mode, you have to turn off the machine.
- 18 -