Indesit FID20 Instructions For Installation And Use Manual - Page 39

Browse online or download pdf Instructions For Installation And Use Manual for Oven Indesit FID20. Indesit FID20 44 pages. Electric built in double oven

Print Page

Installation

Important

It is essential that the lower cupboard is constructed in the manner illustrated i.e.

having side, back, and roof panels so joined as to provide no apertures which could

permit access to the oven unit when installed.

1. General

The appliance is designed for mounting at a safe level into an oven housing which

must be secured to the backing wall.

2. Ventilation

a. The oven housing unit cabinet dimensions must comply with fig. 4.

b. An air gap of 50mm minimum must be provided at the rear of any top or bottom

cupboards or shelves (see fig. 1).

c. It is necessary that the cabinets are provided with unobstructed ventilation, i.e.

from adjacent cabinetry. This can be done by either raising the base of the

cabinets using the adjusting feet (or spacers) or alternatively by providing a slot in

the cabinet plinth to the dimensions in fig. 1.

d. The air gap at rear allows the warmed air to pass out of the inner cabinet space.

Where it is intended to fit cupboards above the oven unit to ceiling height, it is

essential that the warmed air is exhausted through the front of the cabinet

(see fig. 1).

e. If an oven unit is installed adjacent to a tall cabinet, steam escaping from the oven

when the door is opened could condense on and maybe stain the adjacent

surface. To prevent permanent staining, the adjacent surface should be made of a

material that is heat resisting and easy to clean. Adjacent tall cabinets should not

be deeper than the oven housing cabinet.

3. Final Installation

a. Using a spirit level, check that the housing cabinet is level from side to side and

from front to back in its installed position.

b. Correct any unevenness by placing spacers under the bottom of the cabinet.

Make sure that the cabinet rests firmly on the floor without rocking.

c. Before the oven is fitted, the cabinet must be firmly secured to the backing wall for

stability.

d. The oven unit should now be lifted (this is a two person lift) into the cabinet and

pushed fully home.

e. Finally, the oven is secured to the cabinet by means of the four Pozi Wash Head

screws - two through each side trim.

Remove all packaging material from the grill and oven interior.

List of loose items:

4 x Pozi Wash Head No. 6 x 15mm screws.