AEG OKO SANTO 290-6i Operating And Installation Instructions - Page 13
Browse online or download pdf Operating And Installation Instructions for Freezer AEG OKO SANTO 290-6i. AEG OKO SANTO 290-6i 25 pages. Integrating fridge-freezer
Print Page
If the appliance is fixed to the
side of the kitchen unit, simply
slacken the screws in the fixing
brackets (D), move the brack-
ets as shown in the figure and
re-tighten the screws. Fit cover
(E).
Prior to Initial StartÐUp
¥ Please clean the appliance interior and all accessories prior to ini-
tial start-up (see section: ÒCleaning and CareÓ).
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
WARNING Ð THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety
measures not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate. The rating pla-
te is inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of
having to change the fuse in the plug supplied, a 13 amp ASTA
approved (BS 1362) fuse must be used.
Important!
The wires in the mains lead are coloured in accordance with the fol-
lowing code:
Green and Yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings indentifying the terminals
in your plug, proceed as follows:
36
D734
D
E