AEG 916099340 User Manual - Page 22

Browse online or download pdf User Manual for Dryer AEG 916099340. AEG 916099340 28 pages.

Print Page

www.aeg.com

WARNING!

Deactivate the appliance before carrying out any check.

In case of major problems, the acoustic signals operate, the display shows an

error code and the Inicio/Pausa button may flash continuously:

Error code

E50

E90 or E91

EH0

If the display shows other error codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible

solutions.

11.2 Troubleshooting

Problem

The tumble dry‐

er does not op‐

erate.

Possible cause

Appliance motor overloaded.

Too much laundry or entrap in the

drum.

Internal fail. No communication be‐

tween electronic elements of the

appliance.

The mains supply is unstable.

Possible cause

The tumble dryer is not connected

to the mains supply.

The door is open.

The On/Off button was not pushed. Push the On/Off button.

The Inicio/Pausa button was not

touched.

The appliance is in standby mode.

Remedy

The programme was not comple‐

ted. Remove the laundry from the

drum, set the programme and re‐

start the cycle.

The programme was not finished

properly or the appliance stoped

too early. Switch the appliance off

and on again.

If the error code appears again,

contact the Authorised Service

Centre.

When the appliance is showing

EH0, please wait until main supply

is stable than press start. If the ap‐

pliance pause the cycle without

any indication then press the cycle

start. If the warning will occur

check the power cord / socket in‐

tegrity or main supply.

Remedy

Connect it to the mains socket.

Check the fuse in the fuse box (do‐

mestic installation).

Close the door.

Touch the Inicio/Pausa button.

Push the On/Off button.