Dexter Laundry T1200 Installation & Operation Instructions - Page 9
Browse online or download pdf Installation & Operation Instructions for Washer Dexter Laundry T1200. Dexter Laundry T1200 18 pages. 75lb capacity computer control opl washer
Also for Dexter Laundry T1200: Installation & Operation Manual (18 pages), Owner's Booklet (16 pages)
Print Page
WATER TEMPERATURE PRICING
The washer can be set for different levels of pricing for Cold, Warm and Hot water. The Cold
water setting is considered as the base price, which is the normal washer cycle price.
Stage 4: Warm Water Price – The next step in the pricing program is to set the additional price
for Warm water usage. The additional price is the amount added to the price of a cold wash. The
display will blink first "CH P" indicating cold/hot water mix price and then "00.00". To change
the value, use the Hot temperature button to decrease and the Warm temperature button to
increase. The value will change in 1¢ steps. The range of values is from $00.00 to $99.99.
Note: To not use this feature, set the price to "00.00".
When the desired price is displayed, push the Start button once to store the new value and a
second time to move to the next Coin/Price programming step. To exit the Coin/Price
programming mode, push the Cold temperature button for 5 seconds.
Stage 5: Hot Water Price – The next step in the pricing program is to set the additional price for
Hot water usage. The additional price is the amount added to the price of a cold wash. The
display will blink first "H P" indicating hot water price and then "00.00". To change the value,
use the Hot temperature button to decrease and the Warm temperature button to increase. The
value will change in 1¢ steps. The range of values is from $00.00 to $99.99.
Note: To not use this feature, set the price to "00.00".
When the desired price is displayed, push the Start button once to store the new value and a
second time to move to the next Coin/Price programming step. To exit the Coin/Price
programming mode, push the Cold temperature button for 5 seconds. The Coin/Price
programming mode will automatically exit and return to the Idle mode if no buttons are pushed
for one minute.
Stage 6: Plus Cycle Price -- The next step in the programming sequence is the Plus Cycle
feature. The Plus Cycle adds three (3) minutes of wash time to the wash bath only. The
controller can be programmed to charge a fee for this or the feature can be turned off. The
default setting is off. To turn the Plus Cycle feature off, set the Plus Cycle price to zero.
The display will blink first a "PC P" indicating Plus Cycle price and then price (back and forth).
To change the value, use the Hot temperature button to decrease and the Warm temperature
button to increase. The value will change in 1¢ steps. The range of values is from $00.00 to
$99.99. When the desired price is displayed, push the Start temperature button once to store the
new value and a second time to move to the next Coin/Price programming step. To exit the
Coin/Price programming mode, push the Cold temperature button for 5 seconds.
Stage 7: Decimal Point -- The next step in the programming sequence is the decimal point
display. The display will start blinking back and forth first "dP " (Decimal Point) and then either
"on" (default) or "off". Press the Hot or Warm temperature buttons to select the decimal point
display as "on" or "off". When the desired setting is displayed, push the Start button to store it
and a second time to move to the next programming step.