Aqua PRO ECO500 Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Swimming Pool Heater Aqua PRO ECO500. Aqua PRO ECO500 12 pages. 50,000 btu heat & cool heat pump pool and spa heater

Print Page

SECTION 1 - GENERAL INFORMATION

CONTACTING

www.ECOAQUAPRO.com

Phone

Fax

SAFETY

For personal safety, and to avoid damage to equipment, follow all safety instructions displayed in

this guide. Repair and service of your heat pump must be performed by qualified service personnel.

Failure to properly install, operate, maintain, or repair the heat pump will void factory warranty.

Please note "WARNING" signals relate to personal safety, while "CAUTION" signals promote

avoiding damage to equipment.

Follow all National Electric Codes (NEC) unless State or Local guidelines supersede. When

installing and using your heat pump, basic safety precautions must always be followed

WARNING - Failure to heed the following may result in injury or death. Heat pumps contain no

owner-repairable components. Electrical Installation should be by Licensed Electrician only.

Service to the refrigerant circuit must be performed only by qualified HVAC Technicians.

Heat pumps utilize high voltage and rotating equipment. Use caution when servicing.

Heater contains refrigerant under pressure. Recover refrigerant before opening system.

Prolonged immersion in water warmer than normal body temperature can cause fatal Hyperthermia.

The use of alcohol, drugs, or medication can greatly increase the risk of fatal Hyperthermia.

Persons having an adverse medical history, or pregnant women, should consult a physician before

using a hot tub or spa. In addition, children and the extreme elderly should be supervised by a

responsible adult.

CAUTION - Failure to heed the following may result in equipment damage.

Improper water chemistry can cause damage to pump, filter, pool shell, etc. To avoid equipment

damage, maintain Pool/Spa water per standards detailed later in this manual.

Water flow exceeding max flow requires a bypass. Damage due to excessive water flow will void

warranty.

WINTERIZING

In areas where freezing conditions are a rare occurrence, allow the filtration system to run

continuously throughout the freeze period. Typically, during light freeze conditions, circulating

(moving) water will not freeze. In areas where freezing conditions are prevalent and sustained, the

heat pump must be winterized as follows:

1) Disconnect all electrical power to the heater; turn off circulating pump.

2) At the two (2) connection unions, disconnect the plumbing to the heater (removal is

counter-clockwise).

(877) 278-2797

8:00 a.m. to 5:00 p.m. Eastern time,

Monday through Friday

(888) 610-3839

SAVE THESE INSTRUCTIONS