AVS Bugflector II Installation Instructions Manual - Page 2

Browse online or download pdf Installation Instructions Manual for Automobile Accessories AVS Bugflector II. AVS Bugflector II 10 pages. Hood shield
Also for AVS Bugflector II: Installation Instructions Manual (7 pages), Installation Instructions Manual (7 pages), Installation Instructions (2 pages), Installation Instructions Manual (7 pages), Installation Instructions Manual (7 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (9 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (10 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (6 pages), Installation Instructions Manual (6 pages)

Print Page
AVS Bugflector II Installation Instructions Manual

Installation Steps

Locate and remove (8) nuts that secure front grill to the
10 mm
3
Position hood shield onto hood and align hood shield
holes with the well nut.
5
Reattach the front grill by reinstalling the previously
removed (8) nuts. Hood shield flange should be
between the hood and grill.
10 mm
7
Install bump ons at pre-cleaned locations on
the hood surface where the hood shield may
9
NOTE: Actual application may vary slightly from illustrations.
hood. Set grill aside.
contact.
Insert (2) well nuts into the existing holes on each side
4
Install (1) washer and (1) screw to secure. Tighten
6
Reattach the hood latch to the underside of the hood
by reinstalling the previously removed (2) screws.
8
Page 2 of 3
in the underside of hood.
until snug. Repeat for opposite side.
DO NOT OVER TIGHTEN
Hood
Well Nut
Hood
Shield
Washer
Screw