Dell PowerEdge 2850 Manual - Page 7
Browse online or download pdf Manual for Server Dell PowerEdge 2850. Dell PowerEdge 2850 44 pages. Dell server quick reference
Also for Dell PowerEdge 2850: Install Manual (32 pages), Support Matrix (21 pages), Supplementary Manual (20 pages), Information Update (24 pages), Quick Reference (2 pages), User Manual (30 pages)
Print Page
9
Press on the memory module with your thumbs while pulling up on the ejectors with your
index fingers to lock the memory module into the connector.
10
Locate the RAID hardware key connector on the system board. See the system information
label on the inside of the system cover for the location of the RAID key connector.
11
If you have a PowerEdge 1850 system, go to step 13.
12
If you have a PowerEdge 2800 system, remove the memory cooling shroud by lifting
the release latch and sliding the shroud forward.
If you have a PowerEdge 2850 system, lift up the memory cooling shroud.
13
Insert the RAID hardware key into its connector on the system board and secure the key with
the latches on each end of the connector. See Figure 1-3.
14
If you have a PowerEdge 2800 or 2850 system, replace or lower the memory cooling shroud.
15
If you have a PowerEdge 1850 system, install the RAID battery into the RAID battery holder
with the battery cable pointing toward the back of the system.
If you have a PowerEdge 2800 system:
Position the RAID battery over the RAID battery holder with the battery cable pointing
a
toward the front of the system.
Insert the cable connector through the notch in the riser, which is adjacent to the SCSIA
b
connector on the riser.
Install the RAID battery into the RAID battery holder.
c
If you have a PowerEdge 2850 system:
Position the RAID battery over the RAID battery holder with the battery cable pointing
a
toward the front of the system.
Route the battery cable through the battery cable securing clip.
b
Install the RAID battery into the RAID battery holder.
c
See the Installation and Troubleshooting Guide for more information.
NOTE:
If you are replacing a RAID battery, see the "Battery Disposal" section in your Product Information
Guide for important battery disposal instructions.
16
Connect the RAID battery to the RAID battery cable connector on the riser card.
Activating the Integrated RAID Controller
1-5