Dell S6000-ON Installation Manual - Page 25

Browse online or download pdf Installation Manual for Switch Dell S6000-ON. Dell S6000-ON 41 pages. Open networking
Also for Dell S6000-ON: Getting Started Manual (26 pages), Troubleshooting Manual (29 pages)

Print Page

PSU 2

The PSUs are in a single piece with the PSU fans. You can replace the fan trays individually, but you cannot replace the fans that are

attached to the PSUs. If the fans attached to the PSU fail, you must replace the entire PSU. For fan tray replacement procedures, see

Fans.

WARNING:

Prevent exposure and contact with hazardous voltages. Do not attempt to operate this system with the safety cover

removed.

CAUTION:

Remove the power cable from the PSU before removing the PSU. Also, do not connect the power cable before you

insert the PSU in the chassis.

NOTE:

To comply with the GR-1089 Lightning Criteria for Equipment Interfacing with AC Power Ports, use an external SPD at

the AC input of the router.

AC power supply installation

NOTE:

The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S6000–

ON chassis.

NOTE:

Ensure that you correctly install the PSU. When you install the PSU correctly, the power connector is on the left side of

the PSU and the status LED is at the bottom of the PSU.

NOTE:

If you use a single PSU, install a blank plate in the other PSU slot. Dell Networking recommends using power supply 2

(PSU2) as the blank plate slot.

Remove the PSU slot cover from the S6000-ON—the PSU side of switch.

You may select either of the two PSU slots.

Remove the PSU from the electro-static bag.

Insert the PSU into the switch PSU slot. Insert the PSU exposed PCB edge connector first.

The PSU slot is keyed such that the PSU can only be fully inserted in one orientation.

Power supplies