Allo RemoteControl PROGET ETY 433 4N Instructions
Browse online or download pdf Instructions for Remote Control Allo RemoteControl PROGET ETY 433 4N. Allo RemoteControl PROGET ETY 433 4N 2 pages.
Print Page
INSTRUCTIONS
PROGET ETY 433 4N
Registration: press and hold the button MEM in the receiver (PRG on the control unit).
The receivers LED blinks slowly. Press the button of the remote control you wish to
record and bring it closer until the light of the receivers LED stays always on. When
pressing keep your remote control far from metallic parts, if you are inside your car,
bring it close to the windows; in order to be recognized by the receiver you must press
for at least one second and avoid giving multiple commands in a short period of time
because the commands may not be well understood by the receiver
.
COPYING PROCEDURE
Press and hold both buttons on ETY 433 4N the LED blinks, after five seconds it stays on.
Continue pressing ONLY the button of ETY-433 2C that you want to program and release
the other one, the LED turns off (image 1).
Press the button of the remote control to be copied and get closer to the other one
(image 2) until the LED of EtY 433 4Nturns on the operation is concluded. Test the
remote control which learned the code.
We can recognise that the button was programed with a code different than "B&B Rolling
Code" looking at the blinking of the transmitter that should be of lower frequency. For
some type of remote controls less powerful (anti-thief used) the operation can be harder.
It will be possible that you'll need to place the remote control over the Ety 433 4N to find
the best communication between the antennas of both transmitters. We can recognise
that the button was programed with a code different than "B&B Rolling Code" looking at
Visit our website: www.Alloremotecontrol.com
the blinking of the transmitter that should be of lower frequency.
Warning! ETY 433 4N copies one button at the time, if necessary repeat the operation for
the other buttons. Verify the working conditions of the button you just program.
Visit our website: www.alloremotecontrol.com