Miller XMS 403 Owner's Manual - Page 23

Browse online or download pdf Owner's Manual for Welding System Miller XMS 403. Miller XMS 403 44 pages. 400 volts ce arc welding power source

Print Page

4-4. Remote Receptacle (RCTY)

4-5. Welding Process Selection

L1 LED

L2 LED

L3 LED

L4 LED

P3 Push Button

Press P3 until desired process LED illumi-

nates.

Values and parameters that appear on D1

and D2 are either factory default settings or

last settings entered for the selected pro-

cess.

L1 selection is Manual MIG welding.

D1 value is welding voltage, default is

18.5V (range is 10 V to 50 V).

D2 value is wire feed speed, default is 5.0

m/min (range is 1 m/min to 20 m/min). See

Section 4-11.

L2 Synergic MIG welding (non-pulsed).

D1 value is welding voltage, default is 16.5

V (range is −10 V to 50 V).

D2 value is the unit of measure as determ-

ined in the setup menu. (IPM, MPM, Cur-

rent and Thickness)

When L2 LED is stable the welding arc

is in a Short Circuit or Spray Arc trans-

fer. If L2 is flashing this indicates that

the welding parameters are outside of

the specific setting required for either

arc transfer to exist. This process is

known as Globular Arc transfer. This

process produces considerable un-

desirable welding spatter. It may be de-

sirable to switch to a Pulsed-MIG Arc

transfer to reduce/eliminate welding

spatter.

L3 Synergic Pulsed MIG welding.

7 Pin Remote Receptacle

Ref. 956142645-5-5

D1 value is welding voltage, default is 20

V (range is −10 V to 50 V).

D2 value is the unit of measure as determ-

ined in the setup menu. (IPM, MPM, Cur-

rent and Thickness)

L4 Lift-TIG process (see Section 4-16) or

Stick process (see Section 4-17).

If selected process is TIG:

D1 displays TIG, and D2 value is welding

current, default is 220 A (range is 10 A to

400 A).

If selected process is Stick:

D1 displays Stick welding. Output is not en-

abled until button P7 is set to Output en-

abled mode. Display D1 displays open cir-

cuit voltage (OCV) at approximately 85

VDC. Display D2 displays welding current,

default is 220 A (range is 10 A to 400 A).

OM-244 243 Page 19