Miller ArcStation Owner's Manual - Page 35
Browse online or download pdf Owner's Manual for Welding Accessories Miller ArcStation. Miller ArcStation 44 pages.
Also for Miller ArcStation: Owner's Manual (20 pages)
Print Page
5-3. Installing Optional Dust Tray
Tools Needed:
1/2 in.
hex bit 3/16 in.
2
2
1
AA and ZZ
Side View
1
Dust Tray Rails
Use the supplied four bolts AA and
four locknuts ZZ and install dust
tray rails to the welding table. Be
sure that dust tray rails are on the
inside of the subframe assemblies.
Tighten all bolts and locknuts.
2
Dust Tray
Install dust tray into rail slides as
follows:
Tilt rear of tray down and lift front of
tray up.
Place flange on rear of tray behind
angle iron support.
Lower
front
of
tray
until
approximately level.
Slide tray into position.
OM-244 997 Page 31