Panasonic CT-13R18B Service Manual - Page 12
Browse online or download pdf Service Manual for TV Panasonic CT-13R18B. Panasonic CT-13R18B 33 pages. 13" diagonal monitor-receiver
Also for Panasonic CT-13R18B: Owner's Manual (4 pages), Owner's Manual (4 pages)
Print Page
1. REMOVAL OF ANODE CAP
Read the following NOTED items before starting work.
*
After turning the power off there might still be a potential
voltage that is very dangerous. When removing the
Anode Cap, make sure to discharge the Anode Cap's
potential voltage.
*
Do not use pliers to loosen or tighten the Anode Cap
terminal, this may cause the spring to be damaged.
REMOVAL
1. Follow the steps as follows to discharge the Anode Cap.
Connect one end of an Alligator Clip to the metal part of a
flat-blade screwdriver and the other end to ground.
While holding the plastic part of the insulated Screwdriver,
touch the support of the Anode with the tip of the
Screwdriver.
A cracking noise will be heard as the voltage is discharged.
Screwdriver
Alligator Clip
GND on the CRT
2.
Flip up the sides of the Rubber Cap in the direction of the
arrow and remove one side of the support.
Rubber Cap
CRT
3. After one side is removed, pull in the opposite direction to
remove the other.
NOTE
Take care not to damage the Rubber Cap.
DISASSEMBLY INSTRUCTIONS
GND on the CRT
CRT
Support
Support
INSTALLATION
1. Clean the spot where the cap was located with a small
amount of alcohol.
NOTE
Confirm that there is no dirt, dust, etc. at the spot where
the cap was located.
2.
Arrange the wire of the Anode Cap and make sure the
wire is not twisted.
3.
Turn over the Rubber Cap.
4. Insert one end of the Anode Support into the anode button,
then the other as shown in the figure below.
5.
Confirm that the Support is securely connected.
6.
Put on the Rubber Cap without moving any parts.
2. NOTE FOR THE REMOVAL OF THE
MAIN PCB
When the removal of the Main PCB, remove the hook
first, then draw it in the direction of the arrow.
B-1
Location of Anode Cap
Support
CRT