Panasonic DMC-FT3 Basic Operating Instructions Manual - Page 11

Browse online or download pdf Basic Operating Instructions Manual for Digital Camera Panasonic DMC-FT3. Panasonic DMC-FT3 36 pages.
Also for Panasonic DMC-FT3: Basic Operating Instructions Manual (36 pages)

Panasonic DMC-FT3 Basic Operating Instructions Manual
∫ Handling of the camera
Waterproofing is not guaranteed if the unit is subject to an impact as a result of
being hit or dropped etc. If an impact to the camera occurs, it should be
inspected (subject to a fee) by a Panasonic's Service Centre to verify that the
waterproofing is still effective.
When the camera is splashed with detergent, soap, hot spring, bath additive,
sun oil, sun screen, chemical, etc., wipe it off immediately.
Waterproof function of the camera is for sea water and fresh water only.
Any malfunction caused by customer misuse, or mishandling will not be covered
by the warranty.
The inside of this unit is not waterproof. Water leakage will cause malfunction.
Supplied accessories are not waterproof (excluding strap and silicone jacket).
Card and battery are not waterproof. Do not handle with a wet hand. Also, do not
insert wet card or battery into the camera.
Do not leave the camera for a long period of time in places where temperature is
very low (at ski resorts or at high altitude etc.) or very high (above 40 oC), inside
a car under strong sunlight, close to a heater, on the beach, etc. Waterproof
performance may be degraded.
∫ About the [Precautions] demonstration display
[Precautions] is displayed when the power is turned on for the first time after
purchase, with the side door completely closed.
Please check beforehand to maintain the waterproof performance.
1
Press 2 to select [Yes], and press [MENU/SET].
It will automatically skip to the clock setting screen if [No] is selected before
it starts.
2
Press 2/1 to select the picture.
2: Return to the previous screen
1: View the next screen
It can be forcefully ended by pressing [MENU/SET].
When it is forcefully ended while checking by turning the unit off or pressing
[MENU/SET], [Precautions] is displayed every time the power is turned on.
3
After the final screen (12/12), press [MENU/SET] to finish.
When [MENU/SET] is pressed after the final screen (12/12), [Precautions]
is not displayed from the next time the power is turned on.
This can also be viewed from [Precautions] in the
[Setup]
menu.
(ENG) VQT3L38
11