Panasonic SA-PM86D Operating Instructions Manual - Page 5
Browse online or download pdf Operating Instructions Manual for Stereo System Panasonic SA-PM86D. Panasonic SA-PM86D 36 pages. Dvd stereo system model no. sc-pm86d
Placement of speakers
Speakers are designed identically so that no left or right channel
orientation is necessary.
Caution
• Use the speakers only with the recommended system.
Failure to do so can damage the amplifi er and speakers, and
can cause fi re. Consult a qualifi ed service person if damage
occurs or if a sudden change in performance is apparent.
• Do not attach these speakers to walls or ceillings.
Use only the supplied speakers
• Using other speakers can damage the unit, and sound quality will
be negatively affected.
• Place speakers on fl at secure bases. Take proper precautions to
prevent the speakers from falling if you cannot set them up on an
even surface.
Preparing the remote control
1
Insert so the poles
(+ and –) match
those in the remote
control.
R6/LR6, AA
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
• Do not use rechargeable type batteries.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
DEMO function
7, –DEMO
If irregular coloring occurs on your television.
The front speakers are designed to be used close to a television,
but the picture may be affected with some televisions and setup
combinations.
If this occurs, turn the television off for about 30 minutes.
The television's demagnetizing function should correct the problem. If
it persists, move the speakers further away from the television.
Note:
• Keep your speakers at least 10mm away from the system for
• You can damage your speakers and shorten their useful life if you
• Reduce the volume in the following cases to avoid damage:
• To avoid damage to the speakers, do not touch the speaker cones
2
Do not:
• mix old and new batteries.
• use different types of batteries at the same time.
• take apart or short circuit the batteries.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for
a long period of time. Store in a cool, dark place.
■ Use
Aim at the remote control signal sensor (\ page 10), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
When the unit is fi rst plugged in, a demonstration of its functions may be shown on the
display.
If the demo setting is off, you can show a demonstration by selecting "DEMO ON".
Press and hold [7, –DEMO].
The display changes each time the button is held down.
DEMO OFF
DEMO ON
While in standby mode, select "DEMO OFF" to reduce power consumption.
proper ventilation.
play sound at high levels over extended periods.
– When playing distorted sound.
– When the speakers are reverberating due to a record player, a
microphone (except
For the United Kingdom, Continental Europe,
), noise from FM broadcasts, or continuous
Australia and N.Z.
signals from an oscillator, test disc, or electronic instrument.
– When adjusting the sound quality.
– When turning the unit on or off.
if you have taken the nets off.
5