Diatip CD 600 Economy Operator's Manual - Page 4

Browse online or download pdf Operator's Manual for Lathe Diatip CD 600 Economy. Diatip CD 600 Economy 13 pages. Retipping system

Print Page

Midhage Diatip AB

OPERATING INSTRUCTIONS and HOW TO CUT OFF THE

WORN PART OF THE DRILL BIT AND MAKE NOTCHES

Segment guide

Index pin holder

Decide the number of segments that

should be rebrazed on the new rim of the

core bit. Adjust the index pin holder on

the scale that positions the pin over the

index plate. (Refer to the segment guide

located at the end of this manual).

Select the side (A or B) of the indexing

plate that corresponds to the core bit

dimensions.

Index plate – this image shows side B

Make sure the surfaces are clean before

placing the index plate on the blank base

plate. Then place the index pin holder in

position over the index plate.

When mounting the core bit the guide pin

should always lay in one of the holes of

the Index plate

Lock the core bit by sliding the core bit

attachment to the end of the slides

(opposite from cutter head). Then twist

the barrel clockwise until the level (1) in

the bottom reach the stop bolt (2). Turn

the barrel so it is fasten properly on to the

core bit attachment. When demounting

the barrel do the same procedure but the

opposite way

May 2003