Axon Synapse HDR07 Technical Manual - Page 11

Browse online or download pdf Technical Manual for Amplifier Axon Synapse HDR07. Axon Synapse HDR07 18 pages. Re-clocking hdsdi distribution amplifiers

Print Page

5 Settings Menu

Introduction

The settings menu displays the current state of each setting within

the HDR07 and enables the item to be changed or adjusted.

Settings can be changed using the front panel of the Synapse

frame (SFR18, SFR08 or SFR04) or Axon Cortex software.

PLL_Set

The HDR07 is capable of re-clocking a range of SDI and HDSDI

transport stream bitrates. PLL_Set is used to set the HDR07 to

the correct bitrate of the incoming SDI or HDSDI signal.

PLL_Set can be set to Autodetect, 143Mb/s, 177Mb/s,

270Mb/s, 360Mb/s, 540Mb/s and 1485Mb/s.

The default setting is Autodetect.

Reclock

The setting item Reclock determines if the incoming signal will

be reclocked by the HDR07. The settings are;

Auto

selection

between

and

Automatic:

Bypass

Reclocked.

Bypass: Does not re-clock the incoming signal

Reclocked: The HDR07 always attempts to re-clock the

incoming signal.

The default setting is Automatic.

ASI_177

The setting item ASI_177 allows an incoming signal of 177Mb/s

to be handled. When ASI_177 is switched Off an incoming

signal with a bit rate of 177Mb/s will not be detected by

PLL_Set.

The Default setting is On.

DDOmute

DDOmute (Direct Digital Out mute) enables the outputs of the

HDR07 to be muted. The settings are On, Off, Input Loss or

PLL Unlock. Set to Input Loss will mute only in case a

carrier loss is detected on the input. Set to PLL unlock will

mute the outputs in case the PLL rate of the input is not available.

The Default setting is Off.