Arcisan Kudos KU06112 Fitting Instructions - Page 2

Browse online or download pdf Fitting Instructions for Indoor Furnishing Arcisan Kudos KU06112. Arcisan Kudos KU06112 3 pages. 75 backlit mirror

Print Page

Fitting Instructions for Arcisan Mirror

Thanks for purchasing an Arcisan mirror. For safety reasons,we kindly ask you to read

this installation and user guide carefully before you install and use the product.

X&Y

FITTING INSTRUCTIONS

1. Handle with care. When unpacked, never place mirror upright on a

hard surface e.g. Tile Floor. Always lay on soft surface.

2. Drill 2 holes on wall surface as per diagram 1 to desired

height.64" from oor to centre of mirror is advised but may be

adjusted as required, Use spirit level to ensure holes are level. If

drilling through tiles, use a ceramic drill bit.

3. Inset rawl plugs into holes and screws into holes.

4. Attach wire from back of mirror to mains wire in accordance with

current IEE regulations. A second person will be needed to hold the

mirror in place.

5. Hang the mirror onto the screws via holes in the frame.

6. Some mirrors may be hung portrait or landscape.

7. A distance of 80 mm is necessary between the sensor switch and

any other object in any direction

8. Enjoy!

GENERAL INFORMATION

This mirror is suitable for Zone 2 or higher and not Zone

0 or 1 (see diagram)

We advise that you consult a quali ed electrician for the

installation.

Switch off electrical supply at mains before tting.

Ensure wall surface is of suitable strength and

construction.

Beware of hidden cables or pipes.

For plasterboard walls, specialist xings should be

purchased from DIY or hardware stores.

The mirror is heavy so you may need assistance.

Turn lights on/off using infra red sensor -leave off when

not in use.

Heat pat turns on with light switch and takes 2/3 minutes

to heat up.

DIMENSIONS

1 - Long press on left key, clock enters in setting up mode.

First number starts ﬂashing. Press the right key to choose

numbers, 1 or 2.

2 - In setting mode, short press on left key, choose number

position to adjust,then press right key to choose the number.