Cisco 400 Series Quick Start Manual - Page 4

Browse online or download pdf Quick Start Manual for Switch Cisco 400 Series. Cisco 400 Series 8 pages. Fasthub 10/100 series
Also for Cisco 400 Series: Configuration Manual (40 pages)

Print Page
Cisco 400 Series Quick Start Manual
Connect the Hub to Other Network Devices
(continued)
(Optional) Install the
3
Switched Uplink Module in
the Hub
Power off the hub.
1
Remove and set aside the screws
2
attaching the faceplate to expansion slot
on the hub. The screws will be used later
in Step 6.
Remove the faceplate from the hub and
3
store it for future use.
Slide the module into the slot
4
card-guides until you feel it touch the
back of the hub.
Push the module firmly until it snaps
5
into place and is firmly seated.
Insert and tighten the screws on the
6
module faceplate.
Power on the hub.
7
DC INPUTS FOR REMOTE
POWER SUPPLY
UP
RATING
SPECIFIED IN MANUAL
100-127 / 200-240 V~
CONSOLE
+5V
@
6A, +12V
@
1A
2A /1A 50 / 60 Hz
DC INPUT
10/100 BASE-TX
DOWN
STAT DUP 100
DC INPUTS FOR REMOTE
POWER SUPPLY
UP
10/100 BASE-TX
RATING
SPECIFIED IN MANUAL
100-127 / 200-240 V~
CONSOLE
+5V
@
6A, +12V
@
1A
2A /1A 50 / 60 Hz
DC INPUT
DOWN
DC INPUTS FOR REMOTE
POWER SUPPLY
UP
100 BASE-FX
RATING
SPECIFIED IN MANUAL
100-127 / 200-240 V~
CONSOLE
+5V
@
6A, +12V
@
1A
2A /1A 50 / 60 Hz
DC INPUT
DOWN
(Optional) Connect to the
Switched Uplink Module
Port
Insert a connector according to the type of
module (10/100 or 100BaseFX), as follows:
•
Note: Use a straight-through cable to
connect two ports when one of the ports is
designated with an X. Use a crossover cable
to connect two ports when both ports are
designated with an X.
•
MEDIA MODULE
STAT DUP 100
MEDIA MODULE
LINK
DUP
TX
RX
MEDIA MODULE
10BaseT/100BaseTX connector—Insert
the connector until it snaps into place in the
module port.
100BaseFX SC connector—Remove the
rubber plugs from the fiber-optic port
on the module and store them for future
use. Insert the connector in the
fiber-optic module port.