Siemens 25 Troubleshooting Manual - Page 10

Browse online or download pdf Troubleshooting Manual for Controller Siemens 25. Siemens 25 39 pages. Combination starters
Also for Siemens 25: Replacement Parts And Instruction Manual (6 pages), Service Manual (12 pages)

Print Page

1. Exposure Codes

Service Manual

Service Instructions

7.13 Checking the kV and tube current (JR)

Connect oscilloscope to D915.TP.KV & D915.TP.JR

Turn the unit ON.

Trigger an exposure with the default values.

Observe the voltage on CRO (1V = 20mA & 1V=20kV) for selected kV & mAs .

7.14 Checking the mAs values

Turn the Unit OFF.

Remove the Shorting Link "mAs +/-" on D920 PCB banana sockets.

Connect mAs meter to "mAs +/ mAs-" on D920 PCB.

Turn the Unit ON.

Trigger the following exposures:

Setting at control panel

Valid mAs values

40kV,200 mAs

190..210 mAs

66kV,100mAs

95...105 mAs

90kV,1mAs

0.9.....1.1mAs

Turn the Unit OFF.

Remove the mAs meter and reinsert the Link on the D920 PCB.

7.15 Adjusting the mAs

Turn the Unit OFF.

Remove the Shorting Link "mAs +/-" on D920 PCB banana sockets.

Connect mAs meter to "mAs +/ mAs-" on D920 PCB.

Turn the unit ON.

Trigger the exposures for default kv & mAs settings.

Observe the mAs meter reading and if it is not within the tolerance (specified in the

Technical Specifications) of set value adjust the P1 on D915 card

7.16 Switching the Collimator Light ON

Switch ON Collimator Lamp. The Halogen lamp will light up and field of light will appear

on the target. The lamp will be switched OFF automatically after 30 seconds.

If the collimator lamp is switched ON and OFF several times within a short

period, overload protection will automatically switch the light OFF. Cool-down periods

are recommended.

7.17 Program Modes for servicing.

To put the Unit into service Mode short the ST link on the D915 and turn ON the unit

.The display will show as follows

P r

Siemens Ltd. Med India

Version 6.0

7-9