Cisco 7926G Administration Manual - Page 2

Browse online or download pdf Administration Manual for IP Phone Cisco 7926G. Cisco 7926G 14 pages. Wavelink avalanche management console
Also for Cisco 7926G: Release Notes (16 pages), Accessory Manual (20 pages), Administration Manual (19 pages), User Manual (10 pages), User Manual (16 pages), Administration Manual (23 pages), Installation Manual (12 pages), Installing Manual (21 pages)

Print Page

Best Practices

• Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Firmware Release 1.3(1) or later

• Configuration Utility (CU) for Wavelink Avalanche

• DHCP server

• Cisco Unified Communications Manager

Best Practices

This section describes the best practices recommended for setting up and using the CU on the Wavelink

Avalanche server.

• Ensure that the phone is registered to Cisco Unified Communications Manager.

• Try out this process with one or two phones before deploying to many phones.

• Set up a VLAN that has access only to the Wavelink server.

• Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this option,

• Configure a Cisco Access Point to use a default SSID of "cisco" with open authentication and no

If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually assign

it.

Note

Do not perform this task if you previously configured the Wavelink server address using DHCP Option

149.

The following sections describe the methods to assign the Wavelink server on the phone.

Set Up Wavelink Server Address from Phone

To assign the Wavelink server from the phone, follow these steps.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

◦ Avalanche Management Console

see

Set Up Wavelink Server Address from Phone, on page

encryption.

Wavelink Avalanche Server