Siemens ED8 FS11E Series Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Hob Siemens ED8 FS11E Series. Siemens ED8 FS11E Series 36 pages. Induction hob with integrated ventilation system

Print Page

(Important safety

information

T he appliance can only be used safely if it is

I m p o r t a n t s a f e t y i n f o r m a t i o n

correctly installed according to the safety

instructions. The installer is responsible for

ensuring that the appliance works perfectly at

its installation location.

Only a licensed professional may connect

appliances without plugs. Damage caused by

incorrect connection is not covered under

warranty.

Dangerous or explosive materials and vapours

must not be extracted.

Ensure that no small parts or liquids get into

the appliance.

Check the appliance for damage after

unpacking it. Do not connect the appliance if it

has been damaged in transport.

This appliance is not intended for operation

with an external clock timer or a remote

control.

Warning – Danger of suffocation!

Packaging material is dangerous to children.

Never allow children to play with packaging

material.

Warning – Danger of death!

Risk of poisoning from flue gases being drawn

back in.

Always ensure that there is an adequate

supply of fresh air to the room if the appliance

is being operated in air extraction mode at the

same time as a non-room-sealed heating

appliance is being operated.

Non-room-sealed heating appliances (e.g.

gas-, oil-, wood- or coal-burning heaters,

continuous flow heaters or water heaters)

draw in combustion air from the room in which

they are installed and discharge the exhaust

gases outdoors through an exhaust gas

system (e.g. a chimney).

Important safety information

With the extractor hood switched on, air is

extracted from the kitchen and the adjacent

rooms – without an adequate supply of air, the

air pressure falls below atmospheric pressure.

Toxic gases from the chimney or the

extraction shaft are sucked backed into the

living space.

There must therefore always be an

■

adequate supply of air.

A supply-air/air-extraction duct alone is not

■

sufficient to ensure compliance with the

limit.

It is only possible to safely operate the

appliance if the pressure in the room in which

the heating appliance is installed does not

drop more than 4 Pa (0.04 mbar) below

atmospheric pressure. This can be achieved if

the air needed for combustion is able to enter

through openings that cannot be sealed, for

example through doors, windows, by means of

a supply-air/air-extraction duct or by other

technical means.

The exhaust air must not be conveyed into a

functioning smoke or exhaust gas flue or into

a shaft that is used to ventilate rooms in which

heating appliances are installed.

If the exhaust air is to be conveyed into a non-

functioning smoke or exhaust gas flue, you

must obtain the consent of the heating

engineer responsible.

Always consult the heating engineer

responsible. They will be able to assess the

house's entire ventilation setup and suggest

the most appropriate ventilation measures.

Unrestricted operation is possible if the

extractor hood is operated exclusively in air

recirculation mode.