Ricoh PRO C7200 Cip Training - Page 5

Browse online or download pdf Cip Training for Printer Ricoh PRO C7200. Ricoh PRO C7200 12 pages. Printer driver installation guide
Also for Ricoh PRO C7200: Operating Instructions Manual (44 pages), Cip Training (28 pages), Cip Training (16 pages), Cip Training (18 pages)

Print Page

CIP Training Pro C7200 series

Throughput

• After you switch the main power on, a screen may appear to indicate that the machine is

initializing. Do not switch the power off during this process. Initialization takes about 18 minutes.

However, the time for initialization may differ depending on which options are installed on the

machine.

• If the machine does not turn on even if you press the main power switch, open the front left cover

and make sure that the AC power switch is turned on.

• Application icons appear on the [Home] screen as the applications start running.

Turning Off the Main Power

• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord.

Pulling the cord can damage the power cord. Use of damaged power cords could result in ﬁre

or electric shock.

Do not turn off the power while the machine is in operation.

•

Do not hold down the main power switch while turning off the main power. Doing so forcibly turns

off the machine's power and may damage the hard disk or memory and cause malfunctions.

Open the main power switch cover, and then push the main power switch.

The main power indicator goes out. The main power turns off automatically when the machine shuts

down. If the screen on the control panel does not disappear, contact your service representative.

Saving Energy

This machine has the following energy saving functions.

Fusing Unit Off mode

If you do not use the machine for a certain period after an operation, the machine makes a clicking

sound and enters Fusing Unit Off mode.

When the machine is in Fusing Unit Off mode, the display is on but the fusing unit heater is off to

save energy. In this mode, you can change the machine's settings on the control panel. However,

the machine must exit this mode to print.

You can change the amount of time that the machine waits before switching to Fusing Unit Off

mode under [Fusing Unit Off Mode (Energy Saving) On/Off]. For details, see "System Settings",

Device Management.

To exit Fusing Unit Off mode, start print jobs.

The time required to return from Fusing Unit Off mode and resume printing is as long as the time

required for warm-up time. For details about the warm-up time.