Cisco 4500-M Upgrade Manual - Page 22

Browse online or download pdf Upgrade Manual for Network Router Cisco 4500-M. Cisco 4500-M 24 pages. Upgrading memory
Also for Cisco 4500-M: Installation Manual (18 pages), Replacement Manual (16 pages)

Print Page

Replacing Network Processor Modules

Take the following steps to replace a network processor module:

Step 1

Step 2

Step 3

Step 4

Caution

underlying motherboard could be damaged. The maximum screw torque is 7 inch-lb.

Replacing the Component Tray

Take the following steps to replace the component tray in the chassis shell:

Step 1

Step 2

Replacing the Final Connections to the Router

Take the following steps to make the ﬁnal connections to the router:

Step 1

Step 2

Warning

and reinstate power by moving the handle of the circuit breaker to the ON position.

Step 3

Step 4

22 Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory

Hold the network processor module by its handle, align it with the grooves in the chassis

(not shown) and over its connector, and push it lightly against the chassis wall. (See

Figure 7.)

Gently, without bending the connector pins, push the network processor module into place,

inserting the male network processor module connector into the female network processor

module connector on the motherboard.

Replace the module mounting screw on the end of the network processor module. (See

Figure 7.)

If the module has external rear mounting screws to attach the network processor module to

the rear of the chassis, replace the screws at this time.

Do not overtorque the module mounting screw. The network processor module or the

Reinsert the component tray into the shell, pushing on the back of the tray while at the same

time pressing on the chassis release screw (see Figure 3) with the thumb of your right hand.

Retighten the chassis release screw.

If you have an AC-powered system, plug the system power cord into a 3-terminal,

single-phase power source that provides power within the acceptable range (100–240 VAC,

50–60 Hz, 3.0–1.5 A).

If you have a DC-powered system, rewire the DC-input power supply (40 to 72 VDC) to

the terminal block. The proper wiring sequence is ground to ground, positive to positive,

and negative to negative. (See Figure 17.) After connecting the DC power cables, use a

screwdriver to reinstall the terminal block cover.

After wiring the DC power supply, remove the tape from the circuit breaker switch handle

Turn ON the system power switch. The power LED on the front should go ON.

Check the OK LED on the right side of the front panel (see Figure 1) to verify that it goes

ON after a few seconds delay when booting.