Cisco AIR-AP1010 - 1000 Series Lightweight Access Point Quick Start Manual - Page 23
Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco AIR-AP1010 - 1000 Series Lightweight Access Point. Cisco AIR-AP1010 - 1000 Series Lightweight Access Point 36 pages. Aironet 1000 series ieee 802.11a/b/g lightweight access points with internal antennas
Print Page
Installation and Configuration
Figure 8
5.
Note
Be sure the cables are routed away from the AP antennas.
When the AP is powered up and is associated with a Cisco Wireless LAN Controller (Green/Power and
Note
Yellow/802.11b/g and/or Yellow or Amber/802.11a LEDs lit), the AP begins broadcasting its beacon
signal(s). When this happens, complete the installation as quickly as possible to remove yourself from
within 8 inches (20 cm) of the AP to comply with FCC RF radiation exposure guidelines.
You have installed the AP. Repeat
with
Flush Wall Mount
When you are mounting the AP against a wall (flat side toward the inside of the building), use an optional
separately orderable flush-mount bracket.
1.
Note
The AP threaded holes have precision-depth threads. Do not overtighten the screws, or the bracket will
not fit under the screw heads.
7817146-01
Attaching the AP to the Projection-Mount Bracket
Attach the cables to the sides of the AP.
"Returning MAC
Information".
Before proceeding, gently screw the two factory-supplied screws and spring washers into the bottom
of the AP. Be sure the spring washers have their convex (high center sections) pointing toward the
screw heads.
AP1010 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with Internal
"Mounting the Access
Points"
Mounting the Access Points
for each AP location, and then continue
11