Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Quick Start Manual - Page 36

Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco AIR-AP1020 - 1000 Series Lightweight Access Point. Cisco AIR-AP1020 - 1000 Series Lightweight Access Point 44 pages. Aironet 1000 series ieee 802.11a/b/g lightweight access points with external antennas

Print Page

1. Installation and Configuration

Plenum-mounted Cisco Aironet 1000 Series 802.11a/b/g lightweight access points MUST BE powered using

Caution

PoE to comply with safety regulations.

•

About Physical Security

Regardless of the mounting type selected, the Cisco Aironet 1000 Series lightweight access point can be

secured with a Kensington MicroSaver Security Cable. If required, use any MicroSaver Security Cable to

attach either side of your Cisco Aironet 1000 Series lightweight access point to a solid beam, pipe, or support.

FCC Statements for Cisco Aironet 1000 Series Lightweight Access Points

This section includes the following FCC statements for the Cisco Aironet 1000 Series lightweight access

point:

•

Class A Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense. [cfr reference 15.105]

AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide

A-4

When you are mounting the Cisco Aironet 1000 Series lightweight access point in the middle of a

ceiling, ceiling plenum, or hallway, you will typically use the color-coordinated ceiling-mount base

to stabilize the Cisco Aironet 1000 Series lightweight access point after it is mounted. Use the

mounting base to mark the sheet metal, drywall, or other screw locations.

The mounting base attaches to the bottom of the Cisco Aironet 1000 Series lightweight access point

with two supplied screws, and then the assembly slides and locks onto two sheet metal, drywall, or

other screws.

When you are mounting the Cisco Aironet 1000 Series lightweight access point out from a wall (flat

sides along the room or hallway), use the projection-mount L-bracket supplied with the Cisco

Aironet 1000 Series lightweight access point. Use the L-bracket to mark the sheet metal, drywall,

or other screw locations.

When you are mounting the Cisco Aironet 1000 Series lightweight access point against a wall (flat

Side A toward the inside of the building), use the flush-mount bracket supplied with the Cisco

Aironet 1000 Series lightweight access point. The flush-mount L-bracket is the one with one long

and one short leg. Use the L-bracket to mark the sheet metal, drywall, or other screw locations.

Class A Statement

RF Radiation Hazard Warning

Non-Modification Statement

Deployment Statement

Appendix A

Planning Notes

78-17147-01