Cisco TelePresence System C20 Plus Getting Started Manual - Page 17
Browse online or download pdf Getting Started Manual for Conference System Cisco TelePresence System C20 Plus. Cisco TelePresence System C20 Plus 46 pages. Telepresence conference system
Also for Cisco TelePresence System C20 Plus: User Manual (44 pages), Getting Started Manual (35 pages), Getting Started Manual (32 pages)
Print Page
Cisco TelePresence Video Systems
Contents
Configuration using TRC5 remote control and on-screen menu*
Waking up the system
If there is no menu on screen, press
Home
control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been switched
on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If there is still no menu on screen, make sure the monitor cable
is connected to the basic video output connector. If in doubt,
see the installation guide for your product.
* This section does not apply for SX10, SX80, EX Series and MX Series.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
(
) on the remote
Configuration
Configuration
Remote control and
on-screen menu
17
Getting Started Guide
Appendices
Contacts
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.