Cisco 3020 - Cisco Catalyst Blade Switch Release Note - Page 31

Browse online or download pdf Release Note for Network Hardware Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 41 pages. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Also for Cisco 3020 - Cisco Catalyst Blade Switch: Getting Started Manual (37 pages), Getting Started Manual (31 pages), Quickspecs (12 pages), Release Note (27 pages), Release Note (23 pages), Release Note (21 pages), Installation Manual (21 pages)

Print Page
Cisco 3020 - Cisco Catalyst Blade Switch Release Note
Error Message GBIC_SECURITY_CRYPT-4-UNRECOGNIZED_VENDOR: GBIC in port [chars]
manufactured by an unrecognized vendor
Explanation
but the switch could not match its manufacturer with one on the known list of Cisco SFP module
vendors. [chars] is the port.
Recommended Action
module. You might need to upgrade your software.
Error Message GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port [chars] has bad
crc
Explanation
but it does not have a valid cyclic redundancy check (CRC) in the EEPROM data. [chars] is the port.
Recommended Action
module. You might need to upgrade your software. Even if the switch does not recognize the SFP
module, it might still operate properly but have limited functionality.
Error Message PHY-4-UNSUPPORTED_SFP_CARRIER: Unsupported SFP carrier module found in
[chars]
Explanation
unsupported non-Cisco SFP module. [chars] is the interface.
Recommended Action
Error Message PORT_SECURITY-6-ADDR_REMOVED: Address [dec]:[enet] exists on port
[chars]. It has been removed from port [chars].
Explanation
configuration conflicts with the running configuration and has been deleted. [dec]:[enet] is the MAC
address of the port. [chars] is the reconfigured port.
Recommended Action
Error Message WCCP-5-SERVICEFOUND: Service [chars] acquired on WCCP Client
[IP_address]
Explanation
WCCP client. [chars] is the name of the service, and [IP_address] is the client IP address.
Recommended Action
OL-8918-03
The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,
Ensure that the Cisco IOS software running on the switch supports the SFP
The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,
Ensure that the Cisco IOS software running on the switch supports the SFP
The switch has identified the small form-factor pluggable (SFP) module as an
Remove the unsupported SFP module, and use a supported module.
A routed port is reconfigured as a switch port. The address in the previous switch
No action is required.
Web Cache Communication Protocol (WCCP) has found a service on the specified
No action is required.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(35)SE and Later
Documentation Updates
31