Cisco PIX 525 User Manual - Page 9

Browse online or download pdf User Manual for Network Hardware Cisco PIX 525. Cisco PIX 525 30 pages. Security appliance
Also for Cisco PIX 525: Datasheet (13 pages)

Print Page
Cisco PIX 525 User Manual
Chapter 6
PIX 525
If you are using Stateful Failover, use one of the following types of connections, that is appropriate for
Step 5
your system, between the dedicated interfaces on the PIX security appliance units:
•
•
Caution
Do not turn the power on until the units are connected and the primary unit is configured completely.
Power the primary unit on first, then power on the secondary unit. Within a few seconds, the active unit
Step 6
automatically downloads its configuration to the standby unit.
If the primary unit fails, the secondary unit automatically becomes active.

Removing and Replacing the PIX 525 Chassis Cover

This section describes how to remove and replace the chassis cover from PIX 525. This section includes
the following topics:
•
•
Removing the Chassis Cover
Removing the PIX security appliance chassis cover does not affect your Cisco warranty. Upgrading the
Note
PIX security appliance does not require any special tools and does not create any radio frequency leak.
To remove the chassis cover, perform the following steps:
Read the Regulatory Compliance and Safety Information document.
Step 1
Power off the PIX 525 and disconnect site power.
Step 2
Note
Place the PIX 525 so that the front panel is facing you. If you place the PIX 525 on a table, ensure that
Step 3
you have clear access to all sides.
Remove the four screws on the chassis cover. (See
Step 4
78-15170-02
100BaseTX full duplex on a dedicated switch or dedicated VLAN of a switch
1000BaseSX full duplex on a dedicated switch or dedicated VLAN of a switch
Removing the Chassis Cover, page 6-9
Replacing the Chassis Cover, page 6-11
The power switch is part of the power supply.
Removing and Replacing the PIX 525 Chassis Cover
Figure
6-8.)
Cisco PIX Security Appliance Hardware Installation Guide
6-9