Cisco Prisma EtherLinX Installation Instructions Manual - Page 30

Browse online or download pdf Installation Instructions Manual for Network Hardware Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 pages.

Print Page

Device-Specific Configuration,

If VLAN functionality is already enabled and you wish to make changes, when you

type vlan and press Enter, you are immediately taken to the VLAN Definition

screen. Refer to the screen examples in the dl_Open Mode— Configuring Multiple

VLAN IDs Per Port and Configuring a VLAN ID for Each Port.

You can define up to 15 VLAN IDs. Valid VLAN IDs are 1 to 4,094.

Notes:

• SNMP can only be a member of one VLAN ID; therefore, you cannot enable Tags

on SNMP traffic.

• You can assign each port plus SNMP a priority in the VLAN Definition screen.

The high and low priority is determined by the Base VLAN of the unit. Use the

PrismaView software to set the Base VLAN priority; this value is not configurable

via a serial/Telnet session.

dl_Open Mode— Configuring Multiple VLAN IDs Per Port

Make sure to configure the unit for dl_Open mode and reboot the unit. Upon

enabling VLAN functionality, the following screen appears.

When using dl_Open mode, define up to 15 VLAN IDs. Configure the Uplink port

for Tags in order for it to accept VLAN tagged traffic. In this mode, you can

configure Downlink ports as Members of various VLAN IDs.

When defining a VLAN ID for SNMP, the Uplink port should also be a member of

this VLAN ID. Configure a Downlink port to be a member of the SNMP VLAN only

if desired.

Continued

Continued on next page

4008226 Rev B