Cisco RSP7000 Installing - Page 7

Browse online or download pdf Installing for Network Hardware Cisco RSP7000. Cisco RSP7000 26 pages. Upgrade kit in the cisco 7000 series routers
Also for Cisco RSP7000: Installation And Configuration Manual (48 pages)

Print Page

•

Place a removed component on an antistatic surface or in a static shielding bag. If you plan to

return the component to the factory, immediately place it in a static shielding bag.

•

Avoid contact between the component and clothing. The wrist strap only protects the board from

ESD voltages on the body; ESD voltages on clothing can still cause damage.

Caution

measurement should be between 1 and 10 megohms.

Software Prerequisites

The RSP7000 upgrade kit requires that your Cisco 7000 series router is running Cisco Internetwork

Operating System (Cisco IOS) Release 10.3(9), or later, Release 11.0(6), or later, or Release 11.1(1)

or later.

The show version and show hardware commands display the current hardware conﬁguration of the

router, including the system software version that is currently loaded and running. The

show microcode command lists the bundled microcode (target hardware) version for each processor

type. The show controller cbus command shows the microcode version you are running. (For

complete descriptions of show commands, refer to the Router Products Conﬁguration Guide and

Router Products Command Reference publications.)

You can determine the current version of software or microcode stored in ROM either by removing

the processor module and checking the ROM labels or by conﬁguring the system to boot the system

software or microcode from ROM, reloading the system, and using show commands to check the

version that is loaded and running. Refer to the appropriate software documentation for complete

conﬁguration instructions and examples.

If the displays indicate that the required system software and microcode is not available in your

system, contact a customer service representative for upgrade information. (Refer to the section

"Customer Information Online" at the end of this document.)

Hardware Prerequisites

You must install the RSP7000 in the appropriate chassis' 7000 RSP slot. (See Figure 1, on page 2,

for the Cisco 7000, or Figure 2, on page 3, for the Cisco 7010.) For the RSP7000 to operate properly,

the Cisco 7000 and Cisco 7010 chassis must also be conﬁgured with the RSP7000CI.

List of Tools and Parts

Following are the tools and equipment that you will need to complete this replacement:

•

ESD-prevention equipment (a disposable wrist strap is included with all spares and upgrade kits)

•

Antistatic mat, foam pad, or bags for the removed RP and SP (or SSP) (Immediately place all

removed boards into antistatic bags if you plan to return them to the factory.)

•

Number 2 Phillips or 3/16-inch ﬂat-blade screwdriver to loosen the processor module captive

installation screws, and replace the RP and SP (or SSP) with the RSP7000 and RSP7000CI

boards

•

The RSP7000 upgrade kit, which includes the RSP7000 and the RSP7000CI

For safety, periodically check the resistance value of the antistatic strap. The

Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

Installation Prerequisites