Cisco SCE 1000 and Quick Start Manual - Page 5
Browse online or download pdf Quick Start Manual for Network Hardware Cisco SCE 1000 and. Cisco SCE 1000 and 49 pages. Service control engine 1000 2xgbe
Print Page
Attach the Brackets to the SCE 1000
Before installing the SCE 1000 in the rack, you must first install an appropriate rack-mount bracket on each side of the front
of the SCE 1000, as illustrated in the following figures.
Figure 4
Attaching the Mounting Brackets (4-post)
PW R A
PW R B
STA TUS
BYP ASS
MN G 1
MN G 2
CO NSO LE
LINK /
AU X
LINK RX
10/1 00/
TX
ACT IVE
1000
LINK /
10/1 00/
ACT IVE
1000
RX
MM
TX
GBE -1
SUB
LINE
Figure 5
Attaching the Mounting Brackets (2-post)
PW R A
PW R B
MN G 1
MN G 2
CO NS OL
E
AU X
LIN K/
10/ 100 /
AC TIV E
LIN K/
100 0
10/ 100 /
AC TIV E
100 0
To install the rack-mount brackets on the SCE 1000 chassis, complete the following steps:
Before installing the SCE 1000 in the rack, you must first install a rack-mount bracket on each side of the front of the SCE 1000.
Align the rack-mount bracket to the side of the SCE 1000. Choose the proper bracket for your installation (2-post rack
Step 1
or 4-post rack) as illustrated in Rack-Mount the SCE 1000
Step 2
Insert and tighten three screws.
Repeat steps 1 and 2 on the other side of the SCE 1000.
Step 3
If mounting the SCE 1000 in a rack with only two posts, skip to Mount the System to the Rack.
If mounting the SCE 1000 in a rack with four posts, proceed to the next step, Installing the Crossrail Supports
(Four-post rack only), page 6).
C is co S
C E 10 00
Se rie s
2x G B E
LINK RX
TX
RX
MM
TX
NET
ST AT US
BY PA SS
C is c o S
C E 1 0 0 0
S er ie s
LIN K RX
2 x G B E
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
1
2
1
2
5