Cisco UCS E Series Installation Manual - Page 38

Browse online or download pdf Installation Manual for Server Cisco UCS E Series. Cisco UCS E Series 46 pages. Ucs e series unified computing system
Also for Cisco UCS E Series: Product Overview (8 pages), Troubleshooting Manual (28 pages)

Print Page

Installing and Replacing the Memory DIMMS

Remove the screws holding the faceplate to the PCIe card.

Step 6

Slide the PCIe card assembly out through the opening of the faceplate carrier.

Step 7

Installing the PCIe Assembly

Procedure

Step 1

Connect the wrist strap clip to an unpainted portion of the chassis frame to channel unwanted ESD

voltages to ground.

Turn off power to the router.

Step 2

Note

Connect the PCIe connector on the flex assembly to the PCIe card. See the figure in the

Step 3

PCIe Assembly" section on page

Slide the plastic PCIe support over the end of the PCIe card.

Step 4

Reconnect the PCIe flex assembly to the motherboard. Be careful that you do not stress any connector

Step 5

contacts.

Reinstall the M3 screw securing the PCIe assembly.

Step 6

Install the screws to secure the plastic PCIe card support.

Step 7

Tighten the PCIe card faceplate screws.

Step 8

Secure the PCIe card to the faceplate carrier using the faceplate captive fasteners.

Step 9

Installing and Replacing the Memory DIMMS

Caution

Always wear an ESD-preventive wrist strap and ensure that it makes good contact with your skin when

you remove or install DIMMs. Connect the equipment end of the wrist strap to the metal part of the

chassis.

Handle the DIMMs by the edges only. DIMMs are ESD-sensitive components and can be damaged by

Caution

mishandling.

Only trained and qualified personnel should be allowed to install or replace this equipment. Statement

Warning

1030

Hardware Installation Guide for Cisco UCS E-Series Servers

Alternatively, the Cisco 3900 ISR G2 and the Cisco ISR 4451-X support OIR. See the

Insertion and Removal" section on page

37.

29.

"Online

"Removing the

OL-26447-03