Motorola APX Mobile Instruction Manual - Page 37
Browse online or download pdf Instruction Manual for Two-Way Radio Motorola APX Mobile. Motorola APX Mobile 46 pages. Dual-radio o7 control head system
Print Page
APX Dual-Radio Installation: Trunk Units
• Connect the DC Power Cables (P/N HKN4192_), to each radio. Connect the other end of the
cables to the battery terminals (RED POSITIVE).
• Install the O7 Control Head, refer to the APX Mobiles And Control Heads Installation Manual
(P/N 6878215A01).
• Install two speakers (P/N HSN4031_).
• Connect the Primary speaker to the on-line connector on the control head power cable.
Connect the Secondary speaker to the accessory connector on the Secondary radio
transceiver. Use the Speaker Extension Cable (P/N HKN6246_), if additional length is needed.
• Install the antennas as per instructions provided with each antenna, refer to the APX Mobiles
And Control Heads Installation Manual (P/N 6878215A01).
• Connect the Control Head CAN Cable between the Primary Radio and the O7 Control Head.
• Connect the Dual Stack Radio CAN Cable (P/N HKN6249_), between both radios.
• Connect the Palm Microphone (P/N HMN1090_), to the front of O7 Control Head.
SPEAKER 1
EMERGENCY
SWITCH
MIC
CLIP
MIC
07 CONTROL
Figure 5-3. Stack Mount Installation For APX Mobile Mid-Power Dual-Radio O7 Control Head System
5.2.1.3 Dual-Radio Combined Audio Configuration
Speaker audio from each radio is routed into an audio combiner box located inside the enclosure.
The combined audio is routed via the Dual-Radio Accessory Cable (HKN6250_) to a single speaker,
mounted on the handlebars, and to an accessory plug for headset audio. Separate audio signals are
not available in the Dual-Radio Combined Audio Configuration.
MN000770A01-AA
BATTERY
(+)
(-)
FUSE
CAN CABLE
HEAD
NOTE: If only one radio is to be installed in the Dual Trunnion, HLN7045_,
place in bottom mounting configuration.
FUSE
FUSE
DC POWER
CABLES
FUSE
BLOCK
SECONDARY
RADIO
DUAL
STACK
PRIMARY
RADIO
SPEAKER 2
ANTENNA
ANTENNA
July 30, 2014
5-3