Motorola ASTRO Digital XTS 3000 Basic Service Manual - Page 33
Browse online or download pdf Basic Service Manual for Radio Motorola ASTRO Digital XTS 3000. Motorola ASTRO Digital XTS 3000 48 pages. Handheld radio
Also for Motorola ASTRO Digital XTS 3000: Operator's Manual (12 pages)
Print Page
Universal
Connector
Cover
Installing the
Universal
Connector Cover
Removing the
Universal
Connector Cover
Frequency
Knob
Removing the
Frequency Knob
Installing the
Frequency Knob
!
When the universal connector is not in use, keep it covered
with the universal connector cover.
C a u t i o n
1. Looking at the antenna side of the radio,
insert the top (flat) hooked end of the cover
into the slot on the top of the radio, above
the universal connector. Press downward on
the cover's top to seat it in the slot.
2. While holding the cover seated in the top
slot, insert the cover's bottom (rounded)
hooked end into the slot below the universal
connector. Press firmly inward on the cover's
bottom until it snaps in place.
1. Looking at the antenna side of the radio,
insert a flat-bladed screwdriver into the area
between the lower end of the universal
connector cover and the slot below the
universal connector.
2. Pry upward on the cover's lower end until it
disengages from the radio.
NOTES:
•
Refer to Figure 8, the Partial Exploded View, and Table 12, the
Partial Exploded View Parts List. Numbers in parentheses ( ) refer to
item numbers in Figure 8 and Table 12.
•
The battery (7) should be removed from the radio before installing
or removing the frequency knob (1).
1. Hold the radio in one hand so that the top of the radio faces upward, and
the front of the radio faces you.
2. With the other hand, grasp the frequency knob (1) and pull it upward,
while pushing it toward the back of the radio, until it is free from the
frequency insert (3).
3. While pressing the insert's (3) two snap tabs away from the frequency
control shaft so that the insert disengages from the shaft, use needle-nosed
pliers to lift the insert up and off of the frequency control shaft.
4. Remove the secure lever (4) and the lightpipe (5).
1. Hold the radio so that the top of the radio faces upward, and the front of
the radio faces you.
Top
Top
Slot
Hooked End
Bottom
Hooked End
Bottom
Slot
23