Motorola MaxTrac 300 Operating Instructions Manual - Page 32
Browse online or download pdf Operating Instructions Manual for Radio Motorola MaxTrac 300. Motorola MaxTrac 300 37 pages. 6-frequency conventional fm radio
Also for Motorola MaxTrac 300: Operating Instructions (2 pages), User Manual (10 pages)
Print Page
Sleeve–Mounting Bracket Installation
Your low-band, 35–watt 800MHz, and 30–watt 900MHz radios utilize a specially
designed three-point sleeve mounting bracket for on or below dash mounting. To
mount your radio on the floor, an optional accessory, the mounting wedge, is
available (Motorola kit number HLN9450).
Dash mount your radio as follows:
(1)
Select the location to mount your radio either ON THE DASH or BELOW
THE DASH (see Figure 5).
(2)
Using the sleeve-mounting bracket as a template, mark the positions of the
holes on the mounting surface.
(3)
Centerpunch the spots you have marked and drill a 5/32" hole at each.
(4)
Secure the sleeve mounting bracket to the surface with the four (10-16 x
3/4") screws provided.
(5)
If there is sufficient room in the rear of the bracket to install the M5 x 0.8
x 10mm screw, proceed with step (7).
(6)
Install the tapered stud and nut in the rear hole of the sleeve-mounting
bracket as shown in Figure 5.
(7)
Insert the radio into the sleeve-mounting bracket guiding the tapered pin
into the hole in the rear of the heat sink. Secure it with the two thumb
screws provided. If you have skipped step 6 above, install the M5 x 0.8 x
10mm TORX
(8)
To complete your radio installation, plug the power cable into the radio
power connector. Mount the antenna using the instructions provided with
the antenna kit. Run the coaxial cable to the radio mounting location. If
necessary, cut off the excess cable and install the cable connector.
(9)
Connect the antenna cable connector to the radio antenna connector on
the rear of the radio.
(10)
Mount the microphone clip. Follow instructions provided with the
microphone clip.
(11)
Plug the microphone into the front panel connector. Your microphone has a
telephone-type connector at the end of its cord. Connect and disconnect
your radio microphone in the same manner you connect and disconnect a
telephone handset.
30
Begin Installation (cont.)
Sleeve Mounting Bracket Installation
®
screw in the rear of the bracket to secure the radio.