Toshiba 13J2KCVRG-T Installation Manual - Page 15

Browse online or download pdf Installation Manual for Air Conditioner Toshiba 13J2KCVRG-T. Toshiba 13J2KCVRG-T 32 pages.

Print Page

Gas Leak Test

• Check the flare nut connections for the gas leak with a gas leak detector

or soap water.

Remote Control A-B Selection

• When two indoor units are installed in the same room or adjacent two

rooms, if operating a unit, two units may receive the remote control signal

simultaneously and operate. In this case, the operation can be preserved

by setting either one remote control to B setting. (Both are set to A setting

in factory shipment.)

• The remote control signal is not received when the settings of indoor unit

and remote control are different.

• There is no relation between A setting/B setting and A room/B room when

connecting the piping and cables.

To separate using of remote control for each indoor unit in case of 2 air

conditioner are installed near.

Remote Control B Setup.

1. Press [RESET] button on the indoor unit to turn the air conditioner ON.

2. Point the remote control at the indoor unit.

3. Push and hold [CHECK] button on the Remote Control by the tip of the

pencil. "00" will be shown on the display (Picture 1).

4. Press [MODE] during pushing [CHECK]. "B" will show on the display

and "00" will disappear and the air conditioner will turn OFF. The Remote

Control B is memorized (Picture 2).

Note : 1. Repeat above step to reset Remote Control to be A.

2. Remote Control A have not "A" display.

3. Default setting of Remote Control from factory is A.

OTHERS

Check places for

the indoor unit.

Check places for

the outdoor unit.

Test Operation

To switch the TEST RUN (COOL) mode, press [RESET] button for

10 seconds. (The beeper will make a short beep.)

OPERATION /

RESET Button

Auto Restart Setting

This product is designed so that, after a power failure, it can restart

automatically in the same operating mode as before the power failure.

Information

The product was shipped with Auto Restart function in the off position.

Turn it on as required.

How to set the Auto Restart

1. Press and hold the [RESET] button on the indoor unit for 3 seconds to

set the operation. (3 beep sound and OPERATION lamp blink 5 time/sec

for 5 seconds)

2. Press and hold the [RESET] button on the indoor unit for 3 seconds to

cancel the operation. (3 beep sound but OPERATION lamp does not

blink)

• In case of ON timer or OFF timer are set, AUTO RESTART

OPERATION does not activate.