Arisco BW800 Instruction Manual - Page 15

Browse online or download pdf Instruction Manual for Washer Arisco BW800. Arisco BW800 19 pages. Glass washing machine

Print Page

• Take out the overflow pipe and empty the tank completely.

• If this is not a solution for the problem, change the level switch.

• Opening and closing the stand by switch, check the solenoid valve. If it does not work, change it by new one.

• Washing tank is slowly being filled.

• Be sure that the tap supplying water is open.

• Check the water pressure, if it is lower than 202 kpa, use the pressurizing pump.

• Remove the water supplying hose. Take apart the filter of solenoid valve and clean it

• Be sure that rinsing nozzles are not plugged

• Be sure that overflow pipe completely sits in its housing. If there is pressure reducing valve, take it out.

• Machine is not heating washing and rinsing water :

• After checking that overflow pipe is connected to its place, be filled the washing tank.

• Check whether or not the thermostat of rinsing water boiler is set to 80 ºC, and the thermostat of washing water, to 50ºC

• Check the cables and their connections.

• Washing tank is not being emptied:

• Washing tank can not be emptied due to solid wastes. Inspect the water drainage hose from overflow pipe to siphon on the

ground. Be sure that it is clean.

• Machine is not efficiently working:

• Be sure that pump suction filter is clean

• Be sure that the nozzles of washing buttery are clean

• Be sure that adequate amount of detergent is delivered to the machine.

• Selected washing program is very short due to the fact that the pots are dirty

• Select the longer program and run again the machine.

• Check whether water temperature in washing tank is correct or not.

• There is no drying: (Models with drying system)

• Be sure that the amount of polisher injected to the machine is correct

• Check the thermostat of rinsing water is set to 80 ºC.

• Condensation in the glasses.

• Do not store the glasses on a flat surface.

• The amount of dosed polisher is not correct.

• Striped glasses:

• Use only foamless detergent.

• There is excess amount of foam in washing tank:

• Water temperature in washing tank must not be lower than 50ºC.

• Check the detergent and polisher dosing apparatus. There cam be excessive dosing

• Be sure that machine was mot cleaned by foamed detergent. Empty the tank and boiler.

• If foamed detergent was used, empty the tank and be filled it by fresh water. Continue to make this operation until the foam

disappear.

• There is stain on the glass :

• Decrease the amount of dosed polisher. Acceptable dosage is 0,1 cc / liter water.

• The arms of washing buttery are not correctly rotating.

• Remove the washing arm and clean it.

• Be sure that water pressure is more than 202 kpa, If the pressure is lower, mount a pressurizing pump.

15 / 19