Whirlpool UXT2030AYW0 Installation Instructions And Use & Care Manual - Page 9

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool UXT2030AYW0. Whirlpool UXT2030AYW0 28 pages. 30" (76.2 cm) and 36" (91.4 cm) range hood

Print Page

Remove the screw from the terminal box cover. Remove

terminal box cover and set aside.

A. Terminal box cover

B. Screw

Remove the power supply knockout from the top or rear of

the vent hood (depending on the incoming location of your

home power supply cable) and install a UL listed or CSA

approved 1/2"strain relief.

A. Power supply knockout

4. Using 2 or more people, lift the hood into final position. Feed

enough electrical wire through the 1/2"UL listed or CSA

approved strain relief to make connections

in the terminal

box. Tighten the strain relief screws.

5. Position the range hood so that the large end of the keyhole

slots are over the mounting screws. Then push the hood

toward the wall so that the screws are in the neck of the slots.

Tighten the mounting screws, making sure the screws are in

the narrow neck of slots.

6. Connect ventwork to hood. Seal joints with vent clamps or

duct tape to make secure and airtight.

7. Check that back draft dampers work properly.

Mc <® E

ccl Connec

Electrical

Shock Hazard

Disconnect

power before servicing.

Replace all parts and panems before operating.

Failure to do so can resumt in death or electrical

shock.

1. Disconnect

power.

A. White wires

B. Black wires

C. UL listed wire connector

D. Green (or bare) ground wire

E. Home

power

supply

cable

power

cord

accessory

kit

F. UL fisted

or CSA approved

7/2" strain

relief

G. Green

ground

screw

2. Use UL listed wire connectors

and connect white wires (A)

together.

3. Use UL listed wire connectors

and connect black wires (B)

together.

Fire Hazard

Electrically

ground the blower.

Use copper

wire.

Connect ground wire to green ground screw in

terminal

box.

Failure to do so can resumt in death, fire, or

electrbai

shock.

4. Connect green (or bare) ground wire from power supply to

green ground screw in terminal box and securely tighten.

5. Install terminal box cover.

6. Reconnect power.