Xerox 6180N - Phaser Color Laser Printer Getting Started Manual - Page 27

Browse online or download pdf Getting Started Manual for Software Xerox 6180N - Phaser Color Laser Printer. Xerox 6180N - Phaser Color Laser Printer 34 pages. Color laser printer
Also for Xerox 6180N - Phaser Color Laser Printer: Installation Manual (34 pages), Specification Sheet (2 pages), User Manual (32 pages), User Manual (28 pages), Install Manual (2 pages), Security Manual (38 pages), Release Note (2 pages), Install Manual (2 pages), Getting Started Manual (37 pages), Manual (34 pages), Manual (34 pages), User Manual (32 pages), Installation And Operation Manual (8 pages), Evaluator Manual (16 pages), Specifications (4 pages)

Print Page

4. Tools and Utilities

This chapter includes the various software tools and utilities used

with the DocuSP software.

A UNIX command line utility included allowing the ability to bind

more than 125 sheets of paper for the DocuTech 61xx printers

only.

Changing the Binding Limit

Perform the following steps to modify the number of pages that can

be bound from 125 to 128.

1. In the background, right-click to open the menu. Open a

terminal window.

2. Login as root user.

3. Type: /opt/XRXnps/bin/setBind128 –f # and press

<Enter>, where # equals 1 to set the limit for bind jobs to 128

and # equals 0 to set the limit for bind jobs to 125.

4. Close the terminal window. Restart the DocuSP software.

♦ The Set Retain PDL feature on the DocuSP is limited to retain

only 50 completed jobs for future printing. Depending on the size

of retained jobs and the size of the internal hard drives; a lower

value may be more appropriate for some customers.

♦ A UNIX utility named setretainPDL has been added to the

DocuSP to allow the user to specify the number of jobs to be

retained within a range of 1 to 100.

♦ Customers who use the Set Retain PDL feature must be aware

that monitoring the disk capacity is the responsibility of the end-

user. The DocuSP does not have a process for indicating when

the disk is full. Increasing the number of retained jobs should

only be done if the customer is confident that this will not fill the

controller hard drive. Approaching disk capacity can prevent job

transmission or otherwise impact system behavior.