Zanussi ZDV 12001 User Manual - Page 11

Browse online or download pdf User Manual for Dishwasher Zanussi ZDV 12001. Zanussi ZDV 12001 16 pages. Dishwasher

Print Page

1. Control Panel

Alarm code

• The indicator of the set programme flashes contin-

uously.

• The end indicator flashes 3 times intermittently.

Warning! Deactivate the appliance before

you do the check.

Problem

The programme does not

start.

The appliance does not fill

with water.

The appliance does not

drain the water.

After the checks are completed, activate the

appliance. The programme continues from the

point of interruption.

The washing results and drying results are not satisfactory

Problem

The dishes are not clean.

www.zanussi.com

Possible cause

The mains plug is not connected in

the mains socket.

The appliance door is open.

The fuse in the fuse box is damaged.

The water tap is closed.

The water pressure is too low.

The water tap is clogged or there is

limescale on it.

The filter in the water inlet hose is

clogged.

The water inlet hose has a kink or a

bend.

The anti-flood device is on. There are

water leakages in the appliance.

The sink spigot is clogged.

The water drain hose has a kink or a

bend.

Possible cause

The filters are clogged.

The filters are not correctly assem-

bled and installed.

The spray arms are clogged.

The programme was not applicable

for the type of load and soil.

Problem

The anti-flood device is on.

Connect the mains plug.

Close the appliance door.

Replace the fuse.

Open the water tap.

Contact your local water authority.

Clean the water tap.

Clean the filter.

Make sure that the position of the

hose is correct.

Close the water tap and contact the

Service.

Clean the sink spigot.

Make sure that the position of the

hose is correct.

If the problem occurs again, contact the Serv-

ice.

If other alarm codes show, contact the Service.

Clean the filters.

Make sure that the filters are correctly

assembled and installed.

Remove remaining soil with a thin

pointed object.

Make sure that the programme is ap-

plicable for the type of load and soil.

Possible solution