Zanussi ZFT11105XA User Manual - Page 10
Browse online or download pdf User Manual for Freezer Zanussi ZFT11105XA. Zanussi ZFT11105XA 16 pages.
Print Page
Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Closing the door
1. Clean the door gaskets.
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might
occur for some types of models
when operating outside of that
range. The correct operation can
only be guaranteed within the
specified temperature range. If you
have any doubts regarding where to
install the appliance, please turn to
the vendor, to our customer service
or to the nearest Authorised Service
Centre.
10
Possible cause
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and the
wall unit must be at least 100 mm . Ideally,
however, the appliance should not be
positioned below overhanging wall units.
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
Make sure that there is cold air
circulation in the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
CAUTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Solution
www.zanussi.com