ARO SRB21A-10-P Operator's Manual

Browse online or download pdf Operator's Manual for Power Screwdriver ARO SRB21A-10-P. ARO SRB21A-10-P 8 pages. 20 series right-angle screwdriver

Print Page
OPERATOR'S MANUAL
SECTION
M32
MANUAL
3
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
Released: 5-13-94
Tool Products
Revised: 11-10-95
20 SERIES RIGHT-ANGLE SCREWDRIVER
Models: SRB21A-( )-( )
WARNING
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Pneumatic tools should always be installed and used in accor-
dance with A.N.S.I. 8186.1 "Safety Code For Portable Air Tools."
0
0
0
l
l
0
l
0
0
a
Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure
at the air inlet of the tool.
Disconnect air supply from tool before removinq/installing
bit,
socket or device attached to tool or performing maintenance
procedures.
Keep hands, clothing and long hair away from rotating end of
tool.
Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool.
Tool shaft can continue to rotate briefly after throttle is re-
leased.
Do not lubricate tools with flammable orvolatile liquids such as
kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged label.
Use only accessories
recommended
by ARO.
Repeated prolonged operator exposure to vibrations which may
be generated
in the use of certain hand-held
tools may produce
Raynaud's
phenomenon,
commonly
referred to as Whitefinger
disease.
The phenomenon
produces
numbness
and burning
sensations in the hand and may cause circulation and nerve dam-
age as well as tissue necrosis.
Repetitive
users of hand-held
tools who experience
vibrations
should closely monitor duration
of use and their physical condition.
l
The use of other than genuine ARO replacement
parts may
result in safety hazards, decreased
tool performance
and in-
creased maintenance
and may invalidate all warranties.
l
ARO is not responsible
for customer modification
of tools for
applications
on which ARO was not consulted.
l
Tool maintenance
and repair should be performed by autho-
rized, trained, competent
personnel.
Consult your nearest
ARO authorized
servicenter.
l
It is the responsibility
of the employer to place the information
in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand
Distribution
Center, White House, TN at PH: (615) 672-0321,
FAX: (615) 672-0801.
ARO Tool Products
Ingersoll-Rand
Company
1725 U.S. No. 1 North
l
P.O. Box 8000
l
Southern Pines, NC 2838843000
© 1994 THE ARO CORPORATlON . PRINTED IN U.S.A.
Part of worldwide Ingersoll-Rand