ARO 50 Series Operator's Manual

Browse online or download pdf Operator's Manual for Power Tool ARO 50 Series. ARO 50 Series 8 pages.

Print Page

ARO@

OPERATOR'S

MANUAL

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

Form 49999-055

50 SERIES POWER UNIT

Model 8133

3200 R.P.M.

Edition 3

April 2000

10589471

WARNING

READ THIS MANUAL

CAREFULLY

BEFORE INSTALLING,

OPERATING

OR SERVICING

THIS EQUIPMENT.

FAILURE TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

Pneumatic tools should always be installed and used in accor-

dance with A.N.S.I. 8186.1 "Safety Code For Portable Air Tools."

Operate this motor at 90 p.s.i.g. (6.2 bar) maximum air pres-

sure at the air inlet of the motor.

Disconnect air supply from motor before removing/installing

bit, socket or device attached to motor or performing mainte-

nance procedures.

Keep hands, clothing and long hair away from rotating end of

motor.

Anticipate and be alert for sudden changes in motion during

start up and operation of any power motor.

Never exceed rated r.p.m. of motor.

Wear suitable eye and hearing protection while operating mo-

tor.

Motor shaft can continue to rotate briefly after throttle is re-

leased.

Do not lubricate motor with flammable or volatile liquids such

as kerosene, diesel or jet fuel.

Do not remove any labels. Replace any damaged label.

Use only accessories

recommended

by ARO.

Repeated prolonged operator exposure to vibrations which may

be generated in the use of certain hand-held motors may produce

Raynaud's

phenomenon,

commonly

referred to as Whitefinger

disease.

The phenomenon

produces

numbness

and burning

sensations

in the hand and may cause circulation and nerve dam-

age as well as tissue necrosis. Repetitive users of hand-held mo-

tors who experience vibrations should closely monitor duration of

use and their physical condition.

The use of other than genuine AR0 replacement

parts may

result in safety hazards, decreased

motor performance

and

increased maintenance

and may invalidate all warranties.

AR0 is not responsible for customer modification of motors for

applications

on which AR0 was not consulted.

Motor maintenance and repair should be performed by autho-

rized, trained, competent

personnel.

Consult your nearest

AR0 authorized servicenter.

It is the responsibility

of the employer to place the information

in this manual into the hands of the operator.

For parts and service information, contact your local AR0 distributor, or the Customer Service Dept. of the Ingersoll-Rand

Distribution

Center, White House, TN at PH: (615) 672-0321,

FAX: (615) 672-0801.

AR0 Tool Products

AR0

Ingersoll-Rand

Company

1725 U.S. No. 1 North 0 P.O. Box 8000 0 Southern Pines, NC 2838843000

Ingersoll-Rand

Company.

PRINTED

IN U.S.A.