ARO GV08A-02P-7 Operator's Manual - Page 3

Browse online or download pdf Operator's Manual for Power Tool ARO GV08A-02P-7. ARO GV08A-02P-7 12 pages. Sanders/polishers

SANDER/POLISHER SPECIFIC WARNINGS
FAILURE
TO OBSERVE
THE FOLLOWING
WARNINGS
COULD RESULT IN INJURY.
.
These Sanders and Polishers will operate at the
free speed specified on the nameplate if the air
supply line-furnishes 90 psig (6.2 bar/620 kPa) air
pressure at the tool. Operation at higher air
pressure will result in excessive speed.
l
Use only a sanding pad, buffing wheel or polishing
bonnet with these tools. Do not use any grinding
wheel, bur or metal removing accessory other than
a sanding pad with these tools. Never use an
accessory having a maximum operating speed less
than the free speed of the Sander or Polisher in
which it is being used.
.
When using a pad on a threaded arbor, make
certain the flange nut is tightened securely. Check
the tightness of the flange nut before operating a
Sander or Polisher to make certain it will not
loosen during operation.
.
Before installing a new Motor Housing Assembly,
always select the correct Assembly for the motor
package you are installing.
PLACING TOOL IN SERVICE
LUBRICATION
IRAX No. 10
IRAX No. 28
Always use an air line lubricator with these tools.
We recommend the following Filter-Lubricator-Regulator
Unit:
For USA - IRAX No. C11-03-G00
For International - IRAX No. C16-C3-A29
After each eight hours of operation, replenish the oil
supply. Adequate lubrication is imperarive for satisfactory
tool life.
After each 50 000 cycles or each month, whichever
occurs first, inject approximately 6 cc of IRAX No. 28
Grease into the Grease Fitting (4 1) .
INSTALLATION
Air Supply and Connections
Always use clean dry air at 90 psig. maximum air
pressure. Dust, corrosive fumes and/or excessive moisture
can ruin the motor of an air tool. An air line filter can
greatly increase the life of an air tool. The filter removes
dust and moisture.
Be sure all hoses and fittings are the correct size and are
tightly secured. See Dwg. TPD905-1 for a typical piping
AIR TOOL INLET SIZE
(Dwg. TPD905-1)
GV08A Sanders and Polishers are designed for standard duty sanding and polishing operations in automobile
repair shops and in sheet metal fabrication applications.
3